Purchased from http://www.laptopscreen.com/
Tools Used
·
Screwdriver
o Phillips #00 (or close)
o Slotted #1.0 (or close)
·
Guitar pick (or pry tool)
1. There are (6) screws that
need removed from the front
2. Use the guitar pick (or like item) and run around the outer and inner edge to completely release the frame. You may need to gently pry the hinges to release there catch.
(caution if equipped not to hit the camera or wires with tools)
4. Lay the LCD down to unplug
a. Gently pry the adhesive loose and unplug
5. Remove the (6) screws holding the frame on the LCD. (3) on each side.
5. Remove the (6) screws holding the frame on the LCD. (3) on each side.
6. Place the side frames on the new LCD and plug in cable.
a. Place the LCD in position and insert the (2) screw in the lower corners.
b.Put the cover/frame in place and squeeze gently to snap in place
b.Put the cover/frame in place and squeeze gently to snap in place
c. Insert the (6) final screws and screw covers and you are DONE!
I
personally rate this screen replacement a 4 out of 10. (10 being difficult)
No comments:
Post a Comment